English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

my car doesnt start after i put in new spark plug. anyone know the reason why? i have a b18c1 in my hb. the spark plug are NGK Iridium #bkr6eix-11 My car doesnt crank but you can tell that the car run but not the motor. what i mean by the car run is that you can hear a sound where the car have electric. I also turn on the light to check to see if it was the battery. Also I put back the old spark plug but my car still wouldnt crank. please help!!!
therefore it have power but it wont turn over or crank at all! its like you turning your car without battery.


here what i tried:

tested my starter at kragen and had bought a new starter.
charged my battery at kragen.
change the IG fuse.
replaced the Igition coil.

I have an Clifford Auto immobile as well. well this cause the problem?

here is the video clip check it out to see what u think is the problem.
http://www.youtube.com/watch?v=0Hy3egPEaIQ
http://www.youtube.com/watch?v=jeDPVxciQX0
http://www.youtube.com/watch?v=3FG82StpCC0

2007-03-28 17:19:13 · 5 answers · asked by Sua X 1 in Cars & Transportation Maintenance & Repairs

5 answers

Battery may not have enough cranking AMPs to turn engine.I think you need a new battery.Have a load test done on the battery.Check connections on starter for correct hook up.The auto immobilizer could be the problem.Good luck Sua.

2007-03-28 18:02:42 · answer #1 · answered by (A) 7 · 0 0

If this happened right after you changed the plugs I would start there. Make sure you have the correct plugs in it..cross ref with a different manufacturer.. If they are the correct plugs, check tha gapping again, if the plug gap is to small or to large you may not have enough fire to ignite the fuel. This is where I would start.

2007-03-29 00:32:06 · answer #2 · answered by Steelr 4 · 0 0

Is that a security light on the dash lighting up? Also make sure all your connections in the engine compartment are tight and you didn't knock one loose while changing the plugs.

2007-03-29 00:26:24 · answer #3 · answered by Anonymous · 0 0

make sure that you have the right wire on the right plug THIS MEANS ALL OF THEM

2007-03-29 03:05:17 · answer #4 · answered by smokey 7 · 0 0

did u gap ur plugs? or it could be ur cap

2007-03-29 00:31:11 · answer #5 · answered by Anonymous · 0 0

fedest.com, questions and answers