Thanks to the answerers here, my 1985 Virago 700 is running again. But, it doesn't charge its battery when running. To charge the battery, the voltage needs to be 12.5 volts or more. If I yank out all the fuses except the ignition fuse, it'll get that 12.5. Adding back the headlight and tail light drops it down to 11.7. What tests can I perform on my alternator (and I know nothing about this, so please, give details)? Should I open it up to look at the stator (whatever that is), and if so, how do I open it up? I have a digital multimeter. If I have to replace the stator, would a stator from a 1986 Virago fit into my 1985 motorcycle? Any other suggestions (and please don't say 'replace the whole bike with a Harley 883')?
2007-03-27 08:51:12 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Motorcycles
Find the three wires coming from the stator, they'll be in the plug/plugs that go into the regulator/rectifier unit. Set your meter on Ohms function and check for continuity bewteen the three wires (two at a time), should have continuity at some low Ohm reading. Next check for continuity from the stator wires to engine case, should be NO continuity, if there is stator is shorted and will need to be replaced. You can also check stator output, set meter to AC volts function, fire the bike up check voltage output for the three stator wires (two at a time), holding high idle I think you should see 60-80 volts. If your stator passes all these tests your problem is probably the regulator/rectifier unit. When its charging correctly you should see 13.5-15 VDC accross the battery not 12.5
EDIT: Viragos use a permanent magnet rotor system and do not have brushes. You'll find the regulator/rectifier on the left side of the bike down by the footpeg. Earlier reg/ret units were finned for cooling then later on they did away with the finning for some reason, which was a mistake as they then had a alot of reg/rec failures.
2007-03-27 09:22:03 · answer #1 · answered by Anonymous · 1⤊ 0⤋
At idle many Yamahas do not charge what they should.Check voltage with engine RPM at about 1500 to 2000 RPMs with all lights on to see if voltage is at least 12.5.If not I believe behind the side case that houses the alternator you will find 2 alternator brushes that need to be replaced.
2007-03-27 09:13:51 · answer #2 · answered by (A) 7 · 0⤊ 0⤋
Geo46er has the troubleshooting process down right. And Don is correct in that most motorcycles do not put out enough to charge at idle. It's a compromise because of the wide rpm range.
2007-03-28 11:14:38 · answer #3 · answered by Firecracker . 7 · 1⤊ 0⤋
The early Virago's had undesirable starters and this exchange into difficulty-loose till approximately 1992. the least perplexing element to do is purely replace the starter with a sparkling on that has those difficulty ironed out. the user-friendly motorbike exchange into very sturdy however the starter exchange right into a huge difficulty.
2016-12-08 12:36:32 · answer #4 · answered by Anonymous · 0⤊ 0⤋