my network was reset by a power failure and after that i was stuck in a local/limited ipv4/ipv6 connection.?

Question

I have a DSL modem connection and a wireless router (DI-524). The same think happened with another Linksys router.

Answer 1

I would try powering everything off for about 1 minute, then start with powering-up the DSL modem -- wait until all the lights turn on as expected, then turn on the wireless router and wait for that to sync up, then finally turn on your computer and let it boot up.

If that does not fix the problem, then there's a good chance that the power failure caused one or more of your devices (modem, router, computer) to become damaged. If this is happening a lot, I would check to see whether your electrical service, phone lines, and cable lines coming into the house are properly grounded. You may have a grounding problem which is allowing power hits to enter your home and damage your electronics.

Good luck,

Annorax64

Answer 2

RESET YOUR DSL AND ROUTER YOU MIGHT HAVE TO REBOOT BUT UNLIKELEY