English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

ok please only answers from people who have relevant knowledge and are here to offer help not say things like take it to a garage

ok i have a 1996 vauxhall brava, 2.5 non turbo

4 months ago i replaced the key start with a toggle switch and a push button, for reasons of price rather than asthetics.

monday morning i went to start it after spending all weekend working on it and it would not start, seemed like a problem with the diesel pump.

anyway after alot of cranking the starter began to play up, its either clicks or whirrs and when engaging sometimes made a nasty crunch,

the vehicle had another big truck supplying the power through jump leads.

i have once stripped and rebuilt a starter purely to change the two terminals, but this was on a vehicle that was purely clicking and not whirring,

any ideas??

2007-03-23 06:10:25 · 6 answers · asked by orfeo_fp 4 in Cars & Transportation Maintenance & Repairs

6 answers

It sounds like you may have a couple of problems.

The big truck you where jumping it with was it 24Volt? If so you may have burnt the starter motor out and all the cranking won't have done it much good either.

Start by fully charging the brava battery and try again. Make sure that the battery leads are ok ie no loose connection as this can make starters just click. If no change replace the starter then you will be able to look into the real problem.

What work had you done to it over the weekend?

2007-03-23 07:10:57 · answer #1 · answered by Anonymous · 0 0

the starter pinion gear is only spinning on the shaft and not throwing into drive check the solenoid and electrical connections particulaly the earth connection

2007-03-23 07:30:19 · answer #2 · answered by Anonymous · 0 0

Sounds like the starter and/or bendix gear (crunching noise) is cream crackered.

2007-03-23 06:16:41 · answer #3 · answered by Del Piero 10 7 · 0 0

sounds like the solenoid not working properly give it a belt with a hammer and see if it will work.
otherwise take your starter off and take it to an auto electrician who will test it for you.

2007-03-23 07:22:15 · answer #4 · answered by chunky 5 · 0 0

1st lose jump wires 2nd Bendix stater motor 3rd if engine make rounds fast but engine doest start see any smoke from exhaust pipe if no smoke it mean diesel pump faulty there is smoke it mean heater problem .

2007-03-23 07:34:03 · answer #5 · answered by Anonymous · 0 0

do not flow to somebody like Halfords or comparable "motoring" providers,- Too costly, yet flow to a superb "motor components" discover in telephone e book and so on as they might source the two new or "recon" gadgets off the shelf. those will all carry a manufacturers guarantee.

2016-10-19 10:43:17 · answer #6 · answered by ? 4 · 0 0

fedest.com, questions and answers