i have a 92 ford explorer with an a4ld, and upon removing the transmission, the torque convertor wont pull out, why can this be
and is there a way to pull it out thanks
2007-03-22 13:53:39 · 6 answers · asked by dragongml 3 in Cars & Transportation ➔ Maintenance & Repairs
Well I have to say did you unbolt it from the fly wheel???
2007-03-22 13:58:54 · answer #1 · answered by goldwing127959 6 · 0⤊ 0⤋
I would check to make sure all the converter to flywheel attaching nuts are removed, also I would drain the fluid out of the converter
2007-03-22 21:16:56 · answer #2 · answered by jim a 2 · 0⤊ 0⤋
Oil seal has worn a groove in the output shaft?
2007-03-22 21:18:21 · answer #3 · answered by denbobway 4 · 1⤊ 0⤋
Did you remove the 4 nuts that hold it to flexplate?
2007-03-22 21:12:18 · answer #4 · answered by done wrenching 7 · 0⤊ 0⤋
it must be stuck on the front pump.can you get anything,like a pry bar behind it?
2007-03-22 22:16:49 · answer #5 · answered by Anonymous · 0⤊ 0⤋
i am not sure but i would look for a locking clip.
2007-03-22 21:01:44 · answer #6 · answered by oldtimer 5 · 0⤊ 0⤋