drive shaft,yoke, ect. what do i need to make it work
2007-03-21 22:03:50 · 3 answers · asked by kenjackson1977 2 in Cars & Transportation ➔ Maintenance & Repairs
Take it to a custom driveshaft maker.
You also need a torque converter with the correct stall speed, and adapt the kick down cable.
http://www.customdriveshaft.com/custom.html
2007-03-22 02:31:41 · answer #1 · answered by Indiana Jones 6 · 0⤊ 0⤋
just change end get a 400 frount yoke and new ujoint. also see what raio your rear is. i swaped a 89 rs v6 to a 327\350 and the yoke were the same but the rear was to low geared.
0-60 20 sec. 60-100 2 sec. 100-120 10 sec. revved to high after that 7500 rpm at 120 not good.
2007-03-26 00:17:29 · answer #2 · answered by jsn_ayers 4 · 0⤊ 0⤋
CHANGE THE REAR END . THE 400 TRANNY IS OK BUT THE CAR WAS SET UP FOR A OVER DRIVE AUTOMATIC SO THE GEARING IS NOW ALL WRONG FIND A EARLIER 80'S MODEL WITH A 350 AUTOMATIC USE THE REAR END OUT OF THAT OR CHANGE THE RING AND PINION
2007-03-25 22:58:59 · answer #3 · answered by thumper 3 · 0⤊ 0⤋