2007-03-13 21:33:19 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
Run a tube from bleed valve to inside bottom of glass jar. Rig it so it'll stay submerged when you fill the jar 1/3 full of brake fluid. Pump the brakes with the valve open, expelling all bubbles. Do it gentle like, so you don't make a mess. As long as you don't let the tube suck back any air, you in bidness.
It may take a few times to get out all the air. Make sure to top off the reservoir. Double check your brakes before hitting the road-always.
Good luck.
2007-03-13 21:42:41 · answer #1 · answered by omnisource 6 · 0⤊ 1⤋
well i see you got some good answer, but here another way,, first remove the cap, off the master cil,, the craw under the carm an looseing the brake bleeder ,so it will drip,, watch the fluid in the master cil an add when low, after a few min tight the bleeder,,
2007-03-14 03:07:52 · answer #2 · answered by ghostwalker077 6 · 0⤊ 0⤋
there is a tool called a one man bleeder , it goes on the bleeder screw when it's open, put the other end in a glass jar to capture the old fluid , pump the old fluid out , it has a check valve to prevent contaminated fluid or air from being sucked back in , keep topping off the master cylinder , good luck
2007-03-14 05:49:31 · answer #3 · answered by sterling m 6 · 0⤊ 0⤋
yes,they sell a bleeder screw kits so you can do it yourself.go to http://store.summitracing.com/engsearch.asp?N=700+429489168+115+4294845333
2007-03-13 21:49:00 · answer #4 · answered by bigsportsnut2 5 · 0⤊ 0⤋