Kitchen sink plumbing?

Question

Problem.

The drain plumbing is leaking. The home is 20 years old, and the plumbing here is metal. The setup is as follows: Double sink joined under the sink emptying into a single outgoing drain. Also, a dishwasher inlet is connected to the waste flow of one of the drain piping.

How hard a job is to replace all the plumbing leading from the sink drain into the outlet drain (no leaking here)? Can I use plastic instead of metal? If I can use plastic, is it practical for me to do it myself (with good advise, I can do most anything, like change the brakes on my car)?

Are there any articles on how to do this?

If I send for a plummer, how much $ can I expect to replace the pipes from the kitchen drain?

Answer 1

Go to your Home Depot (or equivalent) store and ask one of the customer service guys in the plumbing section. He should be able to give you step by step instructions. Sometimes they even have little printed instruction sheets.

I don't know how much a plumber would charge. A whole lot more than doing it yourself, I would warrant.

I live in a house that is over 50 years old. Last year I put in shut-off valves for my bathroom sink, which previously had none. They never leaked, and all I had were those CSR instructions.

Answer 2

A sink drain can be replaced very easy usually all the parts can be bought at a home improvement store for about $10.00 total and about 30 minutes to change it . A plumber will cost upwards if 150-200 dollars. A sink drain is usually 1 1/2 Id pipe

Answer 3

It is not hard, the make all the same fittings in PVC. If you go to a real hardware store or plumbing store they even have all the same metal fittings but they are quite a bit more expensive.
You can try and ask the guy at home depot, but he is probably a 16 yr old kid who knows nothing about plumbing, so if you have any questions save them for the hardware store or plumbing shop.

Answer 4

you probably did properly to take pictures. thank you. positioned the "T" returned in because it become in the past. Shorten the piece from the wall to the P-seize so as that it (P-seize) swings into alignment with the tail end (down end) of the "T". i think there is purely sufficient distance to end this. If no longer you would be able to ought to upload a quick piece of pipe or a 40 5 diploma installation with the intention to make issues to line up. in case you are able to no longer get that concept to artwork, plumb the spectacular edge to a T on the piece from the disposal. (you will ought to shorten the pipe coming from the disposal) Then connect the P-seize to that. Now upload a quick piece to get returned from the P-seize to the present ninety deg. installation on the biggest drain. returned, you would be able to ought to upload a quick piece of pipe/40 5 diploma installation to make issues align exact. Use compression fittings to make issues undemanding. once you visit the shop, purchase what you have confidence you choose and then some. shop the receipt and return any unused areas. I do it all the time. Saves having to make one extra holiday to the shop in the midst of a venture. (only make optimistic that not one of the pipes runs up hill on their some time past to the biggest drain.) Dad taught me slightly approximately plumbing, then I further to that via staring at/chatting with Plumbers on job web pages. And something I found out from "trial and blunder", trial and blunder, trial and howdy! What do you be attentive to! it works! Have staying power and you will will too!