How do I remove the ignition barrel in my 1992 Mitsubishi Triton?

Question

I have snapped the key in the barrel and i need to get it out before monday.

Answer 1

Just take the broken key out.
Sometimes a small pair of needle-nose pliers can be inserted in the broken-off part of the key and you just pull it out. Sometimes one of those lady's hair clips can do it.
I have one right here beside me that almost always works -
1 3/4 inches long, spring hinged with the tip smaller and less than half as thin as a paper clip.
It never fails to get the broken key out.
I learned that from a locksmith who used them all the time.

Answer 2

1992 Mitsubishi Triton

Answer 3

Branden he ability the situation the place you stick you key to start up the vehicle. that's the ignition barrel. Ah area ought to fee everywhere from as low as $50 to as much as $500. in case you opt for for type new ring some factors places. if your no longer fussed get a 2d hand one from a vehicle wreckers. Tho make sure they'll conceal the fees if its defective eg. area replace or refund and fee of setting up and removing. and do certainly no longer permit a wreckers in wonderful condition the area.

Answer 4

If you just want the broken key out of the lock, use a dental pick and gently rock it back an forth as you pull it out.

If you plan on replacing the barrel lock, you can just use a dent puller and pop it out.

Answer 5

Disconnect the negative battery cable.

Turn the ignition switch to "run" (as if you were driving)

Push the release pin at the base of the lock assembly and pull it out while holding the pin in.

Answer 6

shoot bottle rocekts into the exhaust pipe and light off firecrackers in the gas tank