how do I fix frozen water pipes in a trailer?

Question

I live in a prefab home bolted to a cement slab.

Answer 1

Your going to have to get up under it. If there's not an opening, you can either get a concrete saw and cut a hole somewhere, or knock a hole out with a sledge hammer. If pipes are not broke, place a small electric heater up under it one with a good fan on it, but keep a good eye on it!! Once you get the pipes fixed or un thawed, slip some foam rubber pipe wrap around them. You'll probably have to cut through the black insulation board to get to them also, try cutting it nice and square so you can replace it. use a key hole saw.

Answer 2

so a lengthy way you've finished fairly some sturdy issues. Open the water tap and then bypass below with a hair dryer. start up warming the pipe from the position it is going into your trailer for the tap you opened, and artwork you before to the position it comes from the floor. this way because the ice thaws, it has someplace chance-free to bypass, out the open tap. (in case you thaw a frozen pipe contained in the middle to aggressively, you would possibly want to stress it adequate to crack it.) lengthy time period you want to characteristic extra pipe insulation or ascertain that your tape is operating. or maybe it truly is frozen correct the position it comes up from the floor, yet before it truly is prootected by your warmth tape?

Answer 3

rent a large capacity propane heater and put it under the trailer for 2-3 hours. after it thaws close up all skirting and leave cold water just trickling to prevent future problems

Answer 4

if it happens once it will happen again

use heat tape it is plugged in when it gets cold and keeps the main line warm

also your dryer may blow down there
run the dryer for a bit it will help warm up down there

Answer 5

use a blow dryer on the frozen section, then insulate the pipe!