thanks firstly
2007-03-06 16:03:53 · 5 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
Are you replacing the molded carpet or just putting in a carpet.
If it is a new carpet molded to fit the car, you need to rmove all the seats before you put it in.
If it is just a carpet it will not mold to the humps and holes in the floor.
2007-03-06 16:15:36 · answer #1 · answered by goldwing127959 6 · 1⤊ 0⤋
first take out the seats then if you can tack out the old carpet take it out so you can use it as a patern if not tape so paper together so you can lay it out like you are laying the carpet and mark it with a marker then put it on the carpet and mark it you also need to take off the metal doors pieces which are screwed in cut it out put so glue on the back and replace it place side plates back on put seats back in
2007-03-07 00:22:11 · answer #2 · answered by sunman07 1 · 0⤊ 0⤋
Yeah. All you really have to do is do it. Which means removing all the trim pieces that hold it--the seats of course--etc. Then just lift it up fold it up and out.
2007-03-07 01:37:34 · answer #3 · answered by richard d 3 · 0⤊ 0⤋
i own a repair shop,and yes i have done a few restorations,and i wish i knew what you needed to know about it I'm sure i could help you with this one,all i can tall you is place it in there before you attempt to cut any off of it,if its a pre-molded set,for it,since you didn't say i don't know what you need to know,good luck.
2007-03-07 00:24:33 · answer #4 · answered by dodge man 7 · 0⤊ 0⤋
i have tried, gave up and went to a upholstery
2007-03-07 00:12:07 · answer #5 · answered by da rinse mode 4 · 0⤊ 0⤋