I am looking for a collar that will fit on an old powerpatic drill press with a 3 inch column. The collar cracked and I need to replace it? Also, suggestions on removing the old collar?
2007-03-06 01:14:26 · 3 answers · asked by justin_m_schumacher 1 in Home & Garden ➔ Do It Yourself (DIY)
Look up the manufacturer on the internet. They will give you instructions and supply you with parts.
2007-03-06 01:26:06 · answer #1 · answered by Anonymous · 0⤊ 1⤋
Mornin,
Since you state OLD, it may be a manufacturer/brand, no longer available? In any case WWW search is a good way to start.
The other suggestions might include,,, is the the "CHUCK" ???
If so, inside the fitting there should be a screw that attaches it to the slide/shaft, that will trun in the oppsite direction as the rotaion direction of the shaft. Difficult? Perhaps?
If/when you get it off, I'd be inclined to take it to a shop that sells similar/new such items to compare sizes/measurements similar or exact, that will be a retrofit on the old shaft, and the thread size of the screw perhaps that held the "collar" CHUCK??? in place.
No offense but is your spelling accurate? "Powerpatic"
I guess this one will nudge me to research it too
Steven Wolf
2007-03-06 02:52:44 · answer #2 · answered by DIY Doc 7 · 1⤊ 0⤋
where did u buy the drill in the first place?
2007-03-06 02:48:22 · answer #3 · answered by Anonymous · 0⤊ 0⤋