2007-03-05 03:15:04 · 7 answers · asked by hbm 1 in Home & Garden ➔ Maintenance & Repairs
220-250 volts line to line, or 110-125 volts either line to ground.
2007-03-05 03:22:14 · answer #1 · answered by Anonymous · 0⤊ 0⤋
the voltage shoul be around 110 volts..(108-120) between the red and white wire and 110 volts..(108-120)..betwwen the black and white wire.. but the voltage should be around 220 ( 218-230) between the black and red wire...no voltage betwwen the white and green ( or bare wire) this is your ground...the white is the neutral wire..the red and black wires each take 110 from the panel off of each leg and add them together to give you the 220 needed...this is the basic answer but hope it helps
2007-03-05 11:30:42 · answer #2 · answered by 80sportster 1 · 0⤊ 0⤋
At the breaker service panel, look at the two wires that connect to each breaker on opposite sides of the panel. Read 240 Volts AC across those two wires with a voltmeter. Read 120 Volts from either breaker wire to ground.
PS Actually the dryer breaker is ganged together typically, but one breaker connects to one 120 VAC side and the other breaker connects to the opposite 120 VAC side for a difference of 240 VAC from side to side (breaker to breaker).
2007-03-05 11:24:03 · answer #3 · answered by bobweb 7 · 0⤊ 1⤋
Black to white -- 120 volts
Red to white -- 120 volts
Black to red -- 240 volts
2007-03-05 12:38:55 · answer #4 · answered by frozen 5 · 2⤊ 1⤋
208/220 phase to phase 110/120 phase to ground. votage variation depend on line load and how your panel is loaded.
2007-03-05 11:28:15 · answer #5 · answered by segabill 3 · 0⤊ 1⤋
110 volts from each one.
2007-03-05 11:38:15 · answer #6 · answered by Anonymous · 0⤊ 1⤋
Can't get any plainer then frozen.
2007-03-05 12:55:50 · answer #7 · answered by robert b 3 · 0⤊ 0⤋