Why wont my 1965 mustang start?

Question

I bought a 65 Mustang. I dont know anything about cars. It wont start. I replaced the voltage regulator, battery, cylonoid, and ignition switch. When I turn the key nohing happens. However It does start when its jumped or I put the screwdriver on the cyloinoid. What else could it be? Any information would be greatly appreciated.

Answer 1

Check the starter solenoid. The small wire should read 12 volts with the ignition switch turned to start. If no voltage then check the ignition switch

Answer 2

I think you have a bad connection between the Battery and or the Starter motor,,,,you may also want to have a look at the ignition switch again,,you may not be getting a proper connection there.
There is also a Voltage regulating Resistor probably on or near the firewall,,check for voltage at both ends.

Answer 3

Hilly: I actual have been twiddling with previous 60 Ford Galaxies for years and being a exterior mechanic you learn dissimilar tricks. i visit anticipate you put in a sparkling battery and it replaced into all working positive. between the 1st issues is a available loose solenoid on the indoors fender. examine to verify the relationship on the two bolts is tight and there's a sturdy floor against the indoors fender. The solenoid could desire to by no potential be loose on the fender. The loud click is frequently the two a bad connection on the solenoid or a hung up bendicks interior the starter. A rebuilt starter getting hung up isn't something new. An previous trick to do is actual hit the starter with a hammer this might in specific circumstances unencumber the bendicks it extremely is frequently hung interior the open place. If it starts after that then the starter could desire to be ok. you are able to attempt leap beginning the automobile yet once you nonetheless hear the loud click it somewhat is in all probability the starter, positioned your hand on the starter and see in case you are able to sense it kick interior. This surpassed off to my 1960 Starliner with new each and every little thing, undesirable starter. additionally undergo in suggestions it somewhat is actual and previous college automobile. you have a three spd with a grasp, get some pals over to push start up the automobile, turn the biggest to the on place push the grasp in and upward thrust as much as approximately 10mph and dad the grasp with the automobile in first kit. you're saying you have factors and condesor I replaced all my V8 Galaxies with the Pertronix Ignitor it extremely is an digital ignition device. it is so ordinary it in simple terms replaces the factors and not the rest, you will not additionally be attentive to its there I actual have had an analogous ones for over 12 years in my autos and that they nonetheless run great. I sent you a link they run approximately $50.00 and somewhat nicely worth it.

Answer 4

i own a repair shop and if the ignition switch goes out on it it wont start off the key switch ,that may be the problem with it,or you may have a cable that's real dirty and wont allow the proper voltage to get to it,,with all that being new on it,it has to be something simple on it,those cars was so simple compared to today's car that we all wish they was still all that easy to work on,good luck,i hope this help,s.

Answer 5

You've got some electrical problems there. Maybe a bad ignition switch. Trace the wiring out or take it to an auto electrical repair shop.

Answer 6

have you try replaceing the fuelabl link wires. it two wires that runs from the starter to the cylonoid they are thin wires that looks like they have a knot on one end

Answer 7

sounds like the starter may be going.

Answer 8

put some gas in it