99 Suzuki swift. Looks like the wire is 24 inches and and connects somewhere above the exhaust.
2007-03-04 02:54:28 · 7 answers · asked by Hilary P 2 in Cars & Transportation ➔ Maintenance & Repairs
follow the wire to the connector. the end of the wire should be attatched to the connector and the O2 sensor will just plug in to it. good luck=)
2007-03-04 03:03:36 · answer #1 · answered by Anonymous · 0⤊ 0⤋
The 02 sensor is screwed in to your exhaust, then the wires from the 02 sensor depending on length is connected to the wire harness,sometimes it is hard to see where the connector is.you just have to dig around and find it, a small flsh light might help
2007-03-04 03:02:34 · answer #2 · answered by Frank K 2 · 0⤊ 0⤋
The oild gentle is for stress no longer point, if that comes on it rather is already too previous due. sounds like it needs a coil %. and a sparkling engine because it rather is wiped out. you may desire to stand data, it rather is a shed and is costing you greater that it rather is properly worth just to maintain it on the line. Scrap it and purchase yet another vehicle.
2016-09-30 04:41:23 · answer #3 · answered by ? 4 · 0⤊ 0⤋
the oxy sensor is screw to manifold and the wire connected to it ,is going to E.C.M.(Electonic Control Module)
the wire has number printed on,so You can see the number at the sensor, and also ,at the E.C.M. connector.
2007-03-04 03:23:54 · answer #4 · answered by Anonymous · 0⤊ 0⤋
it runs in a wire loom which hooks into your E.C.U. which is your computer . the o2 sensor feeds ino to your ecu which decides whether your engine is running rich or lean g h or lean
2007-03-04 03:03:07 · answer #5 · answered by dodgewbrown 1 · 0⤊ 1⤋
wiring harness... that goes to to ecm
2007-03-04 03:09:19 · answer #6 · answered by edna b 3 · 0⤊ 0⤋
It should be on the exaust maniflod.
2007-03-04 03:03:36 · answer #7 · answered by david d 5 · 0⤊ 1⤋