100% it must be out side !!!! all they have to do is extend it so it terminates through the facia board ????of the new roof
2007-03-04 00:26:40
·
answer #1
·
answered by Anonymous
·
1⤊
0⤋
I think you are a bit confused in saying the bath overflow is inside because all bath overflows are connected to the bath waste fitting . If you mean the overflow for the water tank, then it is quite easy to extend that yourself. If it is a plastic overflow pipe, then you need to buy some a lenght of plastic overflow pipe and a plastic straight connector. Join the new pipe onto the exsisting pie with the connector, and push the end of the new pipe outside by pushing it under the slates. If it is copper pipe then you will need the same fittings . You need a length of 22mm pipe and a 22mm connector, compression type. Good luck.
2007-03-04 01:06:37
·
answer #2
·
answered by Anonymous
·
0⤊
0⤋
The bath overflow goes out of the bath and into the bath outlet that comes from the plug outlet. This should be connected to the large soil and vent pipe to the sewage system. No need for any other pipe from that overflow. Over flows going to the external wall only come from storage, feed and expansion tanks or cisterns.
2007-03-04 01:43:38
·
answer #3
·
answered by ANF 7
·
0⤊
0⤋
Explain more clearly - bath overflow is already inside - it runs from the plug chain holder (the vented bit under tap) into a joint under the bath - if you mean a tank overflow - then they should have extended the pipe to an external point
2007-03-04 00:25:54
·
answer #4
·
answered by jamand 7
·
0⤊
0⤋
It is a vent pipe not an overflow pipe. it allows your drian to vent air out instead of air gurgling back through your toilet or tub/sink and washing machine. when youI flush or open your drain plugs say after a bath your pipe fills with water and such and the air in your pipe has to go somewhere( like water in a bottle tipped all the way upside down) so it goes up through the pipe instead of back up the potty or sink drain or washing machine.If it still makes you nervous extend the pipe to somewhere outside
2007-03-04 01:08:13
·
answer #5
·
answered by Anonymous
·
1⤊
0⤋
You must have a very old bath. Change the waste for a modern one. The overflow will then run into the waste and not outside.
2007-03-04 00:31:01
·
answer #6
·
answered by Anonymous
·
0⤊
0⤋
Ooops, Are they a reputable building company, or were they cowboys. I suggest to you that you get in touch with them to come back and do their job properly. Surely your local building inspector did not miss this on his final inspection. Get in touch too with your local authority planning office to speak to a planning officer.
It is not right that you have your bath overflow indoors, unless it goes down into the main soil pipe.
2007-03-04 00:32:31
·
answer #7
·
answered by ? 5
·
0⤊
0⤋
i am a builder and can tell you that if the overflow is not led either into a drain or to the outside then it will NOT comply with regs
2007-03-04 04:50:47
·
answer #8
·
answered by boy boy 7
·
0⤊
0⤋
I think that you should call another builder and tell them about it. If you want you could call the Builders association or local council planning permissions. ( I think they would know and have plans of what work was done)
Good luck
2007-03-07 14:08:19
·
answer #9
·
answered by dgc1973ent 1
·
0⤊
0⤋