English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

I printed it on the right side I used the iron no steam and it wont iron on what is wrong with this? Help me please!

2007-03-01 07:11:33 · 3 answers · asked by Anonymous in Games & Recreation Hobbies & Crafts

3 answers

are you sure that you printed it on the right side. Is the fusable web old. Try some new webbing.


Jenn

2007-03-01 07:51:36 · answer #1 · answered by Anonymous · 0 0

If it is printed on the correct side (sometimes hard to tell, you could check that out on a corner though), then perhaps the iron isn't hot enough (should be on cotton/wool), or you aren't holding it in one spot long enough (at least 10 seconds at a time, as I remember), or you're not using a hard enough surface (like a board covered with a thin towel... not a padded ironing board), or you're trying to transfer onto a fabric which still has sizing in it from the store (always wash first) or has residual fabric softener from washing and drying (which can act as a release). It could also be the fabric you're using??


HTH,

Diane B.

2007-03-01 16:32:40 · answer #2 · answered by Diane B. 7 · 1 0

Perhaps the fusible material is old?

2007-03-01 15:22:47 · answer #3 · answered by RoseritaRosy 2 · 0 0

fedest.com, questions and answers