2007-02-27 07:22:38 · 3 answers · asked by wseedorff 1 in Cars & Transportation ➔ Maintenance & Repairs
These are pictures of your clutch slave cylinder, one alone and one installed in the trans;
http://partimages2.genpt.com/partimages/580538.jpg
http://www.v6z24.com/jbodyforum/files/thumbs/t_september_26_2006_007_121.jpg
No matter what I believe you were told in another post, yes, you have to remove the transaxle to R&R the slave. I highly recommend also replacing the clutch assembly, the transmission input shaft seal and the engine rear main seal while you're there.
If you have any more Q's and want no sh*t info, e-mail me.
2007-02-27 07:30:21 · answer #1 · answered by vwhobo 4 · 0⤊ 0⤋
A 94 with 3.1 should have the bolt on cyl (2 13 mm nuts). I believe I've changed them on car, but why are you doing it-are you SURE it's bad?
2007-02-27 07:33:31 · answer #2 · answered by done wrenching 7 · 0⤊ 1⤋
no, the slave cylinder is located on the outside of the transmission
2007-02-27 08:51:04 · answer #3 · answered by shefixescars 4 · 0⤊ 1⤋