2007-02-26 06:06:50 · 8 answers · asked by Alan K 1 in Cars & Transportation ➔ Car Makes ➔ Peugeot
This worked for me, but was told it didn't always. Disconnect cable plugs under both front seats. Start engine and run for three or four minutes. Stop engine and re connect plugs. If this does not work, then you will have to contact a reputable auto electrician,or take it to a dealer to have the 'computer' reset.
2007-02-26 06:32:15 · answer #1 · answered by mal g 5 · 0⤊ 1⤋
most of the 306 range had a fault with the wires under the drivers seat and passengers too
you have to take away the orange clip and just solder the wires
very very common fault
turn the ignition on and off three times and then start the car
it should clear the fault
2007-02-26 16:33:11 · answer #2 · answered by gordon_shrek 3 · 1⤊ 1⤋
rip the wire off the warning light
2007-02-26 14:16:53 · answer #3 · answered by country boy 5 · 0⤊ 0⤋
remove the bulb from behind the insrument panel.that ought to the trick.
2007-02-27 07:34:56 · answer #4 · answered by s.cullen01@btinternet.com 1 · 0⤊ 0⤋
Pull out the bulb.
2007-02-26 19:30:25 · answer #5 · answered by Anonymous · 0⤊ 0⤋
If it,s flashing it,s telling you that there is something wrong with the sysytem .Get it checked.This is a safety issue!
2007-02-26 14:10:26 · answer #6 · answered by auto tech25 3 · 0⤊ 0⤋
Stop crashing into things
2007-02-26 14:09:01 · answer #7 · answered by Anonymous · 0⤊ 0⤋
u will have to take ur car back to peugeot to have it reset
2007-02-26 14:15:38 · answer #8 · answered by DIAMOND_GEEZER_56 4 · 0⤊ 0⤋