English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

9 answers

there is most likely 4 oxygen sensors on this truck. 3 of the 4 are between the engine and cat. converter. the 4th one is immediately to the rear of the cat. conv..in the ex. pipe, of course. if you are looking to replace 1 of these, better know which one is bad before you buy it. you got a 1 in 4 shot to get it right the first time... not good odds in my book.

2007-02-25 10:27:10 · answer #1 · answered by Anonymous · 0 2

Could be On the Exhaust Manifold on each side another could be at the Y another could be on the straigh pipe to the catlatic converter and if there is a forth on I have no Clue.

GM Recomends A GM Replacement. DO NOT USE the Univerial. they do Not Fit and you need Adaptors and they do not last.

Best to take it to AutoZone get the code and thake it to the Chevy Dealer give them the code and pay the hafty cost and ask if the Part is Lifetime Warrenty. Mine is on my 2001 Z24 $500 later after they tried a new computer code and then the part took a crap on my was I mad about making 2 trips. I should have only paid $250. I knew what was wrong.

2007-02-25 14:56:18 · answer #2 · answered by stickneypoint 2 · 0 0

1995 Chevy 1500

2016-10-05 10:43:11 · answer #3 · answered by ? 4 · 0 0

in a 95 1500 pick up the 0-2 sensor is located in the left exhaust manifold , just below the steering intermediate shaft

2007-02-25 10:34:45 · answer #4 · answered by h.a x 3 · 1 0

It should be on either the passenger side exhaust pipe close to where it bolts to the exhaust manifold or header, or in the ex. manifold. Most likely in the pipe. A single wire goes to it. It should come out fairly easy. Blow the dust out of the threads in the pipe before assembly.

2007-02-25 10:32:56 · answer #5 · answered by Anonymous · 0 0

Look under the truck close to the oil filter. It should be screwed into the down pipe of the Y-pipe of the exhaust system. Good luck.

2007-02-25 11:43:50 · answer #6 · answered by Deano 7 · 0 0

which sensor do u want to know where it is.Bank 1 sen 1 or bank 2 sensor 1 or bank2 sen 2 or bank 1 sen 2 ?

2007-02-25 10:48:47 · answer #7 · answered by Anonymous · 0 0

Before the cat converter and after the converter.

2007-02-25 11:21:58 · answer #8 · answered by Anonymous · 0 0

on exhaust manifold.

2007-02-25 12:08:57 · answer #9 · answered by racingirl14 3 · 0 0

fedest.com, questions and answers