2007-02-25 04:04:20 · 4 answers · asked by clayvon 1 in Cars & Transportation ➔ Maintenance & Repairs
OK, I am assuming that the tire is no longer on the rim, so this is what you'll need to get it back on the rim:
1. A compressor
2. A can of ether (quick start)
3. A match
Spray inside the tire for 5-10 seconds. Spray a wick in a place outside the tire going into the tire. Have your compressor ready. Lite the wick. The ether will ignite similar to a BBQ that doesn't lite right away so do so at arms length. The resulting explosion propels the tire on the rim. Immediatly start putting air into the tire or it will go flat with the inside vapor cooling. If this doesn't work the first time wait 5 - 10 minute to allow the inside of the tire to ventilate and replace the o2 that was used up. Make sure both the rim and the tire bead are clean. I have used this to get a Bobcat tire back on the rim and it is still holding air after a couple of years.
2007-02-25 04:28:22 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Tie a rope around it and pull real hard so the seams go tight on the rim then use a strong air preasure gauge to inflate , if its been setting to long then the tire might not be anygood /peace
2007-02-25 04:10:28 · answer #2 · answered by Terry S 5 · 0⤊ 0⤋
What you want to do is take a rachet tie strap and wrap it down the middle of the tire. Making the tire evenly close on both sides. (l) In this case the "()" is the tire and "l" is the tie strap. Then blow it up should work no problem. This is also how you blow up ATV Tubless tires.
2007-02-25 04:09:18 · answer #3 · answered by Donkeywood 2 · 0⤊ 0⤋
put air in it. If the bead came off the rim, pull the valve core out and use high pressure air, the when it seats, put the core back in it.
or call AAA and have them come out and do it, or take the wheel off the vehicle and bring it to a tire shop
2007-02-25 04:08:42 · answer #4 · answered by Magikmann 4 · 0⤊ 0⤋