i own a repair shop,and i think one thing that might be wrong with it is you may have a busted transmission mount on it and maybe a bad engine mount,and if the release bearing is going out it will shake a little but it will also make real loud squeal of noise,and you,ll know if its the bearing,i think really what you need to do is take it to a shop and have someone look at it,and see what they say about it,a hands opinion will be helpful to have on this one,they you,ll know for sure what it is, good luck,i hope this help,s.
2007-02-22 04:36:28
·
answer #1
·
answered by dodge man 7
·
0⤊
0⤋
What sounds like is happening is you have one or more motor mounts broken. While the bolts may be tight, the rubber can separate from the bracket. That is why the engine "jumps" quite a bit, from torque.
Clutch throw out bearings can seize, but will make a lot of noise, not make the engine buck like that.
Have the hood open, parking brake set good, and have someone watch while you ease out the clutch...the motor mounts that are broken should be obvious. Identify how many you have first, so you can look at each one.
2007-02-22 04:37:26
·
answer #2
·
answered by Michael B 6
·
0⤊
0⤋
The motor/transmission mounts are most likely shot and need to be replaced. The engine torques and pulls it engine off center.
Take a crow bar and gently lift up on the trans at the mount if it lifts at all the mount is gone. do the same with the engine mounts. I doubt the release bearing is seized as it would squeal like a stuck pig when you engage the clutch. Think about it. there is a lot of torque at your engine and if it is loose it will squirm around like two bobcats in a blanket...... Gezz is that a hick answer or what....
2007-02-22 04:35:03
·
answer #3
·
answered by Uncle Red 6
·
0⤊
0⤋
The Ford broking replaced into B/S ing you to not mess with it... i will replace the applying in the PCM for an hour exertions fee making use of the Ford diagnostic workstation. yet i've got been additionally burned via autozone and different discounter areas too (autozone has a habit of coming up crappy ignition products that look to come again back) probable why they wanted to snow ball it... what style of erratic skipping? Be extra particular the Cyl a million misfire could nicely be from many stuff.. You under no circumstances suggested plug wires although... it quite is my theory of a music up..wires smash down actual person-friendly and reason issues like this often. (purchase actual plug wires like motorcraft.... autozone wires have brought about me too many issues over that) i could could check out it to be sure for particular on what's occurring as a misfire could nicely be brought about via many stuff... please post extra and precisely what it what it quite is doing thank you
2016-12-17 16:16:47
·
answer #4
·
answered by ? 4
·
0⤊
0⤋
Probably because you bought an old car the first thing. Another thing is you don't know how well this car was taken care of through the years. It doesn't matter if it was a Ford or not if someone didn't ever change the oil or do the proper maintenance on it especially if this car as tons of miles on it which it probably does you are going to be having a lot of trouble with it.
2007-02-22 04:39:14
·
answer #5
·
answered by Mrs. Know It All 3
·
0⤊
1⤋
You need a garage to look at it most will tell you whats up without charging you in hope of getting the job..
2007-02-22 07:57:18
·
answer #6
·
answered by Anonymous
·
0⤊
0⤋
you need a new clutch. and motor mount...you cant tell a bad mount by just looking at it,
2007-02-22 04:32:08
·
answer #7
·
answered by Anonymous
·
0⤊
0⤋
what did you buy it for? escorts are s hit.
2007-02-22 04:30:09
·
answer #8
·
answered by Anonymous
·
0⤊
2⤋