Where is the control module located in 2003 Pontiac Montana?

Question

I am talking about airbag control module.

Answer 1

You did not specify which module you were looking for but:
The Powertrain Control Module is located in the engine air cleaner assembly
The Vehicle Communications Interface Module (Onstar) is located under the instrument cluster inside the dash
The Electronic Brake Control Module is located at the left rear of the engine compartment at the brake master cylinder
The Inflatable Restraints Sensing and Diagnostic Module is located under the passenger front seat
The Theft Deterrent Control Module is located in the steering column at the ignition switch
The Body Control Module is located under the right side of the dash just above the insulator panel

Hope that helps

Answer 2

Believe it or not, it is located in the motor compartment underneath the air cleaner box. Or rather it is located in the lower compartment of the air intake filter cleaner box. It is put here for use of room and the air flowing around it helps to keep the module cool. You have to remove the air cleaner top with snorkle, remove the air filter, then start digging and removing all the plastic stuff that make up the intake cleaner box. Make sure you remember how it goes back together as there are a lot of parts to this. Good luck.

Answer 3

I definitely have finished a ton of intake gaskets for that particular same subject, which incorporate my 01 Montana. the unique intake gaskets suck. GM got here out with redesigned set that looks maintaining up lots longer, so once you get them finished, make advantageous they get the intake gasket set from the dealership or AC Delco. the recent gaskets incorporate new intake bolts. After get gaskets are replaced get the engine oil flushed and adjusted and you're able to be solid to flow. you mustn't could hassle with regard to the pinnacle gasket till you overheated the engine. the three.4L engines do no longer postpone properly while overheated. additionally get the thermostat replaced on a similar time as the intake gaskets are being do. it rather is going to be much less demanding and extra fee-effective at that factor.

Answer 4

Need to know what control module your talking about??