I have a rgv 250 of which im trying to bleed the back brake but with no success :(
I have no bleeding pump or kit, can someone please explain to me step by step as im a bit of a egg how to bleed the brakes?
2007-02-19 15:09:56 · 4 answers · asked by pjacques_duplessis 1 in Cars & Transportation ➔ Motorcycles
If you need help and can't get any. Get you a clean soda bottle and fill it about 1/3 full and put a rubber line off of your bleeder screw into the soda bottle to the bottom of the fluid and pump the brake and break the bleeder screw loose and let the air out while holding the break down so air can't go back up the line and repeat. Hope this is understandable.
2007-02-19 15:32:25 · answer #1 · answered by Pommac 6 · 0⤊ 0⤋
Some bikes can be a real pain to bleed doing it the old fashioned way. The easiest and cheapest way is to get a big syringe and a bit of rubber hose from somewhere like a fishing tackle or vetenary supplies shop.
Then simply connect the syringe to the bleed nipple with the hose, crack the nipple open just enough and suck the fluid through.
2007-02-20 07:03:14 · answer #2 · answered by SpannerMonkey 4 · 0⤊ 0⤋
Have someone pump the brakes slowly 3 times and then hold the peddle down while you drain out the fluid filled with air.
You may have to get help. sometimes with different cars you need certain tools.
Good luck.
2007-02-19 23:15:00 · answer #3 · answered by Brandysmom 3 · 0⤊ 0⤋
Make sure reservoir is full.
Open fitting.
Push on pedal. Keep pedal down.
Close fitting.
Release pedal
repeat
2007-02-19 23:12:24 · answer #4 · answered by Anonymous · 0⤊ 0⤋