i jsut need to know if the pully is bolted on or pressed on so i can figure out if i need to buy a new a/c motor or just the pully
2007-02-18 16:45:35 · 3 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
A/C compressor? The pulley/clutch assembly is bolted onto the compressor shaft with a bolt (13mm head) Once the bolt is out, a special puller is screwed into the centre and the push bolt is tightened until the outer clutch plate pops off. It's mounted on a conic shaft and is keyed in place as well. You need this puller. Once off, there is a large snap ring at the base of the pulley, closest to the compressor. Remove the ring and slide the pulley off the field coil. Installation is the reverse of removal, except for the use of the puller. Tightening the centre bolt will seat the clutch plate.
2007-02-18 17:55:47 · answer #1 · answered by shopteacher 4 · 0⤊ 0⤋
press on
2007-02-18 16:52:09 · answer #2 · answered by peanut 4 · 0⤊ 0⤋
pressed on
2007-02-18 16:50:27 · answer #3 · answered by I race cars 4 · 0⤊ 0⤋