English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

im connected with broadband connection that requires user name and pass. I have 2 connections to same provider with 1 i connect and only can recharge the 2-nd , so 1-st connection work. wenn i try connect 2nd if i do not write service name in properties there is a error: wrong user name and pass ; if i write write service name in properties there is a error : the remote computer did not respond. I have 2 LAN cards installed with both is same story.
in my other computer those connections work perfect.
if i change computer(lan card) which i use i call my provider for permission so they cnow that i do not have service name or if i write one they do not see me in network. I reinstall windows and is same story.
Any idea?? or (which part of hardware i have to change ) Thank You in advance.

2007-02-15 21:03:51 · 2 answers · asked by dimitardimitrov2005 1 in Computers & Internet Computer Networking

2 answers

Dont know what you are babblin about but if you have a modem connected to a router, all the provider does is connect to your modem! You aint gotta contact them! Just plug the network cable into the router on the PC that aint workin and run the networking wizard!

2007-02-15 21:17:19 · answer #1 · answered by Anonymous · 0 0

first make sure ur insulation for the modem is correct. and its contiune to do.
only the ip address conflict will be there. so u can go command prompt and give an command as ipconfig, u can see there which ip is assigned for each. if it is same one connection will be work which is connected at first.
so u can give an static ip there. and make sure ur service provider was given any dns address to put in to ur config. u make to write there. it will connect

2007-02-16 05:17:17 · answer #2 · answered by ramesh 2 · 0 0

fedest.com, questions and answers