I just replaced the heating element in my dryer today. The dryer had previously been turning but not heating. I tested the resistance on the element and it gave a reading of infinite resistance.
I put the new element in connecting the wires as they were originally. I turned the dryer on and it heated up - but when I opened the dryer drawer I noticed that the element was glowing RED. I'm sure that's probably not normal, so I'm curious as to what else may be wrong with this dryer or if it's normal and I just never noticed it before.
The dryer is a base model kenmore, I cannot find any kind of model number on it but it's one of the older ones with a 'wood grain' top, black instrument panel and an off-white case.
Any help would be appreciated :)
2007-02-15 10:53:51 · 9 answers · asked by run4god 1 in Home & Garden ➔ Maintenance & Repairs
The elements do not normally glow bright red. They usually glow a dull orangish color.
Check the vent for blockage. It could be kinked or built up with lint or the hood where it goes to the outside could be blocked or the flap could be stuck.
There could be blockage in the filter duct preventing proper air flow. If your filter slides in at the right hand side at the top, remove the two screws that hold the duct fast to the top and remove the rear cover and remove the four screws that hold the duct fast to the blower housing. Pull the duct away from the housing and clean the duct out completely from bottom to top.
Heating elements do not normally burn out on their own but will go bad when there is not enough air going across them. If there is still some blockage in the system the element will have a short life so it is to your benefit to ensure that there is a good proper air flow. This will also shorten the drying time and save dollars off your electric bill.
2007-02-15 14:41:18 · answer #1 · answered by Anonymous · 4⤊ 0⤋
Heating Elements For Dryers
2016-12-11 09:01:25 · answer #2 · answered by forester 4 · 0⤊ 0⤋
If not properly cared for, Gas Dryers can be a hazard. Please understand that they are not dangerous, but they need care just like your fireplace or heating system. The vent out of the back of the dryer needs to be cleaned of lint occasionally, and the lint trap in the dryer needs to be emptied at each use. Improper installation of the vent on a dryer is another area where problems occur. It should not have too many bends in the ductwork, and should not be too long. I hesitate on giving length numbers because they vary by dryer. Mine is about a 6 foot run to the outside. By the way, the red glow is the gas flame, and is normal.
2016-05-24 04:50:25 · answer #3 · answered by Anonymous · 0⤊ 0⤋
Admiral Dryer Not Heating
2016-10-05 07:52:43 · answer #4 · answered by ? 4 · 0⤊ 0⤋
The heating element is similar to a hair dryer. If you turn it on, and look at the end when it's on high, it also will glow red.
The Kenmore, and many other units, have an over temperature relay inside. If the unit over heats, it will turn off the power to the element.
If this isn't happening, dry a load of laundry and enjoy the fact that you repaired the dryer yourself.
2007-02-15 11:24:15 · answer #5 · answered by Bare B 6 · 2⤊ 1⤋
Yes, it should glo red, or orange, as the case may be. You've apparently just never noticed it before. As the one answerer mentioned, with the unit running, the fan on the back of the motor shaft puts out enough air that the coil probably doesn't look quite so red, but it's still very hot.
Did you find the broken spot on the old element once you had it out?
2007-02-15 14:36:45 · answer #6 · answered by Corky R 7 · 1⤊ 1⤋
Yes it is normal for the heating element to glow red when dryer is on.
2007-02-15 12:27:09 · answer #7 · answered by Pat B 3 · 1⤊ 1⤋
Generally while it is running the air blows with enough force that the element will not appear red. But if you shut the blower off, the red will be visible.
Does the dryer, when operating, feel like its putting out the correct heat? If so, its fine.
You must have a fancy one? I repair a lot of things but hair dryers are so cheap I'd just get another.
2007-02-15 11:02:04 · answer #8 · answered by KirksWorld 5 · 1⤊ 4⤋
Did you hook up the ground wire.
They do glow red to a certain extent.
I would try a load of clothes in it and just watch it carefully to make sure it's not getting too hot.
2007-02-15 11:03:04 · answer #9 · answered by Enigma 6 · 0⤊ 2⤋