i have a for focus and the passenger window wont work the drivers one is fine i have changed the fuse as thats what i thought it was but still nothing happening any ideas much appreciated thanks
2007-02-12 04:24:35 · 8 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
it might be the switch, before you buy one pull out the switch & change over the plugs to see if the problem has gone then you know its the switch. or the window is sticking ,press down while helping it with your hand.if its sticking spray with WD40.
OR listen to see if it makes a noise when pressing the swicth, if its making a noise it has come off the runners inside the door pannel.
make sure you've changed the right fuse too. ; )
2007-02-14 21:34:19 · answer #1 · answered by Toby G* 4 · 0⤊ 1⤋
Ignition on engine not running. Get in on the passenger side and work the switch. If the interior dome light dims then the problem is a stuck window motor(seized). If not it could be the switch.
2007-02-12 05:28:44 · answer #2 · answered by cy 3 · 0⤊ 0⤋
Possible causes. Motor is disconnected or broken. Switch is not working. Voltage doesn't get to the switch (try both the master control and the individual window control. Does either work?)
Have it looked at, the panel has to come off most likely to find the cause.
2007-02-12 04:30:41 · answer #3 · answered by oklatom 7 · 0⤊ 0⤋
Unplug both window switches, try the passenger switch on drivers window, (Not working? switch), if it works try other switch on other window,(not working? motor or loose/connection) if it now works then the switch connection was loose.
Happened with mine, turned out the contacts in the switch were badly worn.
2007-02-12 04:42:45 · answer #4 · answered by psychoticgenius 6 · 0⤊ 0⤋
try making it work from your side of the car if that works then u need a new switch otherwise you have a loose connection behind the door panel
2007-02-12 04:31:08 · answer #5 · answered by theemadmonkey 4 · 0⤊ 0⤋
sounds like your window motor is not working they are a pain to replace because of tight fit. but can be done with a little patients
2007-02-12 04:32:02 · answer #6 · answered by ozzyden1960 1 · 0⤊ 0⤋
First of all check if the current is there when you press the button.
secondly if its ok check the motor.
thirdly if motor is also ok check the moving parts if they are jammed.
If could not find the sulotion go to the mchanic
2007-02-12 04:59:55 · answer #7 · answered by Anonymous · 0⤊ 0⤋
sounds like a bigish job if u dont know what u r doin best taking car to an auto electrician who should do it for bout £30 good luck
2007-02-14 23:32:33 · answer #8 · answered by haha_islaughing 2 · 0⤊ 0⤋