does machine start when it reaches the required level of water or it start with time ? I bought new w'machine and noise of water intake is very low and i wonder if its working okie or not? Does it take less water on pre wash? How long pre wash takes at cotton 60 degree?
2007-02-12 00:59:13 · 6 answers · asked by Gagan S 2 in Home & Garden ➔ Cleaning & Laundry
Is the washing machine fitted in accordance with the manufacturer's instructions? Have you carefully followed the instructions om how to operate the machine? Have you even read the instruction book? If your answer to these questions is YES then no problem. Does the instruction book give any information on times taken for the various operations? Have you even read the instruction book? M y advice is to read the instruction book.
2007-02-12 01:04:53 · answer #1 · answered by BARROWMAN 6 · 2⤊ 0⤋
ok, you should have a load capacity knob (small, large etc.), the water will reach the desired level according to which size you adjust it to. The other knobs are for the controlling of the wash style(perm. press, delicare, etc.). That will determine how the machine will wash the clothes and how much time it will take for the cycles(wash, rinse, spin). Pre-wash should be the same amount of water as wash load size. Make sure the water hoses are hooked up correctly, check for leaks, and if it's not filling up all the way and you are doing everything else right... it's time to call the retailer or manufacturer. :)
2007-02-12 01:37:38 · answer #2 · answered by alishus 1 · 0⤊ 0⤋
Without being a washer tech, but understanding some basic principals I have to assume that in the "works" there is a solenoid, a trip switch perhaps that allows the level to be reached as set. I wouldn't go so far as to say it's Rocket Science, but consider thatthe clock/timer is connected by solenoids for various but very valid reasons.
Assume that the clock was the issue, yet water pressure wasn't keeping time with the clock. Your clothing wouldn't be washed at the appropriate setting YOU chose. On the opposite side of that, consider that the clock and water flow were not in synch, but that the FLOAT might not be fucnctioning properly, That might cause a decent water flow to flow over?
Every washer I've ever had also has a point in fill time, where it stops and I hear a kind of back flow, briefly, as the adjustment is being made, by the timer, to begin the next cycle.
Steven Wolf
2007-02-12 01:12:15 · answer #3 · answered by DIY Doc 7 · 0⤊ 1⤋
Most machines will start rotating the drum before the required level of water is reached in order to tumble the clothes and even out the washing load.
2007-02-12 01:05:46 · answer #4 · answered by kinvadave 5 · 0⤊ 0⤋
most washers start when the water level is reached it will then tumble till the right temperature is reached it'll then go through the wash the time it takes to wash is between 40 and 60 minutes
2007-02-12 14:01:18 · answer #5 · answered by Anonymous · 0⤊ 0⤋
Water level, take the hoses off the back of the washer and clean the screens inside the washer fittings.
2007-02-12 01:35:55 · answer #6 · answered by Anonymous · 2⤊ 0⤋