I have a Craftsman Garage opener. I'm planing to get a new extra one, but I don't remember how to program code...Do you know how to do it?
Thank you for your help!
2007-02-11 06:25:02 · 3 answers · asked by wateiku 1 in Home & Garden ➔ Maintenance & Repairs
when you go to buy the remote, take one you already have with you. this will help you to get the correct model although it's not a guarantee. i was in a sears yesterday and had to jump in on a conversation because the salesman was trying to sell a customer the wrong remote...grrr.
to program your remote, 1st get a ladder and go up to the motor case hanging from the ceiling. find the antenna wire (it's a wire about 6 inches long) . on the circuit board the wire is attached to, you will either see a set of dip switches or a square colored button about 1/4" by 1/4". if you see dip switches, set the switches in your remote to match them and you are done. if you see the colored button, press and release that button, then press and hold your remote button. after a few seconds, the remote will program itself. usually the opener will start running when it's done.
2007-02-11 07:13:23 · answer #1 · answered by handsinpants2 3 · 0⤊ 0⤋
I get green light keeps blinking push reset button let go push remote but will not work also the button for manual will not work
2015-04-12 06:24:50 · answer #2 · answered by Paul 1 · 0⤊ 0⤋
they vary from opener to opener go to sears and have them make a copy of the instructions for you then keep the instructions where yo can find them when needed.
2007-02-11 07:01:15 · answer #3 · answered by aussie 6 · 1⤊ 0⤋