2007-02-10 23:55:24 · 4 answers · asked by geegely 2 in Home & Garden ➔ Maintenance & Repairs
Get ready to clean a lot once you get the old one out.
2007-02-11 00:40:15 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Done a few of these and I've found that it's a good idea to have a strong helper, (as they are not light), and a close place to set it on when it comes out, like maybe a roll around cart. If it's electric, it will be 220 volts service and as one of the previous answerers said, it is dangerous and can kill you. Make sure you turn off the juice before attempting any servicing or removal. Depending on who did the initial installation, there may or may not be enough electric line coiled in the back to allow complete removal for access to connections. If there is enough wire, then it's not too bad, if not, then you better have access through some side cupboard. Make sure the new unit has the same rough in measurements as your old unit and it should be a slide out and slide in procedure.
2007-02-11 03:45:44 · answer #2 · answered by Corky R 7 · 0⤊ 0⤋
hi. do all the above answers. go to the elect panel and shut off the breaker marked oven, if there is no marked breaker, then shut off the main breaker. this is usually a 100 amp switch at the top of the panel. after shutting off the breaker, go to the stove and check that it is off, and wont turn on. then open the oven door and on the right and left sides at the front edge you should see 2 screws. remove these and grab hold of the oven door and pull the oven stright out. mark the wires before you remove them so they will hook to the new oven in the same location .
2007-02-13 07:13:35 · answer #3 · answered by mlcabodi@sbcglobal.net 2 · 0⤊ 0⤋
If it is electric, make sure the power is off. That 220 line can kill you.
2007-02-10 23:59:08 · answer #4 · answered by Anonymous · 0⤊ 0⤋