Why is it when I try to turn on my computer it goes Beep..............Beep...............Beep. and the monitor says no signal, the key board doesn't even light up???
sometimes it works fine, but often it does this crap and I have to try for like 30 mins to get it to go.
2007-02-10 11:50:11 · 6 answers · asked by corrick_1 6 in Computers & Internet ➔ Hardware ➔ Other - Hardware
Your computer is going through the post stage of computer startup. Beeps usually means there is an error in your computer. Check the memory modules. Take them out and insert them again to see if they are the problem. Check the CPU.
For me, my computer is custom built and I had the same problem you had. All I did to solve the problem was to swap out a defective memory module.
2007-02-10 11:58:43 · answer #1 · answered by Lionheart12 5 · 1⤊ 0⤋
If you were to look up your model on the manufacturers website, often they'll tell you what the beep sequences mean.
But from the symptoms you listed...my guess would be a bad memory module.
2007-02-10 12:04:28 · answer #2 · answered by Misty 7 · 0⤊ 0⤋
Beep codes is the computers way to tell it's user that somthing isn't right.
Check out the sites for in depth information on beep codes.
http://www.pcstats.com/articleview.cfm?articleID=1223
http://www.computerhope.com/beep.htm
2007-02-10 13:25:53 · answer #3 · answered by Beck92 4 · 0⤊ 0⤋
Make sure of the beep counts. If it is indeed 2 consecutive beeps, it means memory fault. You have to change your RAM memory card.
2007-02-10 12:19:02 · answer #4 · answered by roadwarrior 4 · 0⤊ 0⤋
I think that the RAM is out of coverage, I mean you may need to buy a new one.
2007-02-10 11:56:25 · answer #5 · answered by Hamza 2 · 0⤊ 0⤋
Old, corrupted driver, need upgrade, ur C Drive might be too old and need an upgrade
2007-02-10 11:52:53 · answer #6 · answered by Anonymous · 0⤊ 0⤋