Help finish a paper model of the Whitehouse?

Question

http://papertoys.com/white-house.htm
So, I'm building a model of the white house for my little brother out of paper. I've finished the front dome and the sides, but I can't fit the back and the thing with the PaperToys logo. Could someone post step-by-step instructions or a picture of the finished product?

I've circled the parts here:
http://img67.imageshack.us/img67/9967/whitehousery6.jpg

I know what the White House looks like, but I don't know where to glue/tape those two parts. I've tried bending, folding, cutting, but it's either too long or too short...

Answer 1

If you haven't yet print the image from the pdf file on 65lb or 110lb. card stock (8.5x11). Score all the fold marks with an empty ball point pen or a knitting needle ( nothing sharp that will cut the paper).
Then cut out the image. DO NOT cut off the roof or the base piece, leave the small space where they join intact. Fold tabs in and fold the sides of the building out. Fold around the rotund and glue the side walls to the tabs, do one at a time. Use yellow wood glue, hold with fingers will set in 3 to 5min. the go to net tab. This should only take 30 to 45 min to assemble. I tested the assembly and this works.

Answer 2

http://www.whitehouse.com