2007-02-02 15:05:50 · 9 answers · asked by MoJo 1 in Cars & Transportation ➔ Maintenance & Repairs
there are a few different ways, look in the owners manuel itll tell you, you use the clock on impalas and others and sometimes you use the gas pedal way. the book will tell you.
2007-02-02 15:35:09 · answer #1 · answered by vettle1 3 · 0⤊ 0⤋
To reset oil life monitor Turn ignition switch to run position with engine off. Cycle accelerator pedal from closed throttle to wide open throttle.In other words , step on the gas pedal to the floor and up 3 times with in 5 seconds.Change oil soon lite will flash for 2 seconds when system is reset. If change oil soon lite comes on and stays on for 5 seconds the system did not reset . So repeat procedure . Its as easy as that!
2016-05-23 22:07:01 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Is it a message, or just the light? If its comming from a information panel with lots of buttons like on my GM truck ( fuel left, range, miles traveled, oil life, trans fluid life,etc) then hold the button marked reset till it makes a ding type sound and it should read 100% life and oil light should shut off. Other than this, simply drive to your local GM dealer, ask to talk to a mechanic there, show him the light and offer to slip him 10 dollars if he could reset it for you.Do this incase the service rep says it will cost you an arm and a leg to shut it off,lol. Hope I helped. Jeremy
2007-02-02 15:17:17 · answer #3 · answered by Anonymous · 0⤊ 0⤋
Chevy doesn't make an F2500. They make a "C" or a "K".
Turn the key on (Not started, just ON), Press the accelerator pedal to the floor and completely release it three times within 5 seconds. Turn the key off and wait for 10 seconds, then start the truck.
Happy Motoring
2007-02-02 15:13:11 · answer #4 · answered by Ironhand 6 · 1⤊ 0⤋
Take the cover off the fuse box. There should be a reset button in there. Press the reset button once only. If it has NOT reset the light, press and hold for three seconds.
Hope that helps and good luck.
2007-02-02 15:10:11 · answer #5 · answered by Marc A 2 · 0⤊ 0⤋
You have to turn the ignition on and pree the gas pedal to the floor 3 times and then hit the brake pedal then start your truck and the light will reset itsself
2007-02-02 15:13:00 · answer #6 · answered by lilbit65453 1 · 0⤊ 0⤋
if it is like most chevys then you would turn the ignition on not starting the engine and depress the accelerator three times within five seconds then turn the key off and then start the engine should flash a few times then go out
2007-02-02 15:09:35 · answer #7 · answered by wrenchbender19 5 · 0⤊ 0⤋
turn the key to on,pump the gas pedal 3 times hold it down until the lamp blinks then shuts off
2007-02-02 15:09:54 · answer #8 · answered by bozotexino 4 · 0⤊ 0⤋
disconnect the negative terminal for about 10 min
2007-02-03 03:45:49 · answer #9 · answered by Joe 2 · 0⤊ 0⤋