Well I changed both bulbs and the hazards work, but the left side doesn't flash it goes solids, Right side flashes and hazards work on both sides, I think it has something to do with this weird looking bulb, that was right next to the yellow bulb, their is one hanging down under my dash and one next to each bulb, the one for the right side, is smashed and when i tried to take it out to change it the whole wire came out, and I actually lost it. Is that thingy the flasher, it was yellow and had a small black bulb and two wires, and it was square at its base. is their a way to get a bulb that flashes with out this thing, and if it was the flasher am i going to have to take a apart the whole car.
Also the dash light went out, how do i fix that
and when trying to put in a car sterio the interior lights, and the clock went out, could it be a fuse or something, cause all of the fuses under the hood are fine
2007-02-02 05:57:49 · 2 answers · asked by Ronald P 2 in Cars & Transportation ➔ Maintenance & Repairs
Well, the left side isn't working because there is another bulb burned out in the circuit. Replace that and you will have turn signals again. (Look at the end you didn't change.)
As to the clock and dash lights, quit looking under the hood at the mail fuse box and have a look in the secondary fuse box inside the cab and change the one blown there.
2007-02-02 06:07:57 · answer #1 · answered by oklatom 7 · 0⤊ 0⤋
you will have to find that lost wire , also jeeps are bad for ground faults, clean any ground wires at your flashers . good luck
2007-02-02 08:19:49 · answer #2 · answered by sterling m 6 · 0⤊ 0⤋