The original light was a sinple on-off. The new one has a manual overide. What do i need to do wiring wise to allow for the manual override.
2007-01-31 08:50:27 · 5 answers · asked by Dougie M 1 in Home & Garden ➔ Do It Yourself (DIY)
If the manual override is by means of flicking the switch twice, then just wire it as shown in the instructions, using 2 core and earth cable. If it requires a second switch for override you will have to replace the 2 core/e with 3 core/e, and the single switch for a two gang. (Or change the light)
2007-01-31 09:13:07 · answer #1 · answered by jayktee96 7 · 1⤊ 0⤋
The overide is already built into the light itself you do not need to do anything other than put power to it in the normal way !
2007-01-31 09:00:06 · answer #2 · answered by charlotterobo 4 · 1⤊ 0⤋
nothing just put the light up as you would put up a normal light the manual override is built into the sensor light
2007-02-03 05:09:39 · answer #3 · answered by adrian c 1 · 0⤊ 0⤋
Get an electrician all the way mate or you'l get problems forever!!
Probably cost you a tenner to do it for you!
2007-01-31 08:53:53 · answer #4 · answered by Dave 1 · 0⤊ 1⤋
go with jayktee any doubts call in electrician. electrical trade 40yrs
2007-02-01 07:28:18 · answer #5 · answered by james h 2 · 0⤊ 1⤋