English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories
2

im am trying to change bobcat hydraulic hoses on a 753 you would kinda need a pic so i can show you what im talking about.. it on the left side lower hydraulic arm. there are 2 hydraulic hoses and they drop back to the motor area. and i found a bolt to make them drop but cant seem to get a rinch to get the hoses off the rinch will not fit in the area.. do i need to take off the other hoses to get in there better ?? if you need a pic ill email it just ask!

2007-01-29 14:12:21 · 4 answers · asked by B-Rad! 1 in Cars & Transportation Maintenance & Repairs

4 answers

Extend the bobcat arm out or push it under the cat to jack the front end up, or take off the bracket holding the hose or cylinder, then see if you can get clearance in there. Call the parts and service place and ask them how its done, sometimes they can be helpful too.
You may have to remove some hose brackets on the other lines to get in there.
Have you bought a set of crows feet wrenches? They can get into a tight spot, go to craftsman and look around for specialty wrenches like that.

Good luck!

2007-01-29 14:25:05 · answer #1 · answered by Le Nuez Vert` 3 · 1 0

no need of picture.
the problem is that You don't have bonny wrenches.

in that case yes You have to remove all the hoses and install them in the order of the deep one first.
until You get to the one in the surface

be careful, someone are flaring and someone are straight thread with a high tension "o" ring and a locker nut.
if You haven't done it before, I suggest You to have the service manual near bye

caution. be sure that when you open the hose there is not pressure in it. neither the arm will fall on You.
if you see an sprinkle of hydraulic fluid don't put Your hand in top of it it may go through you sking and is highly poison to You kidneys
may stop them.

2007-01-29 14:26:23 · answer #2 · answered by Anonymous · 1 0

call the bobcat dealer and talk to the parts dude ....

2007-01-29 14:19:43 · answer #3 · answered by XTX 7 · 0 0

rinch?

2007-01-29 14:45:01 · answer #4 · answered by moe h 4 · 0 0

fedest.com, questions and answers