my serpentine belt come off. My question is I would like to bypass the ac compressor pulley by getting a shorter belt. Should this work?
2007-01-29 11:08:22 · 5 answers · asked by pixie 1 in Cars & Transportation ➔ Maintenance & Repairs
Those cars were never offered without AC I will save you the time looking. Also are you positive the ac clutch is the problem as the harmonic balance aka the crank pulley on this model is nototious for problems. If is the ac easiest way to get a belt that will fit is cut the old belt wrap it around all accessories and mark the length then subtract aboubt 1.5 inch to accomodate for tensioner slack. MAKE SURE all other belt routing wont change direction of movement for water pump power steerin alternator.
2007-01-29 18:13:47 · answer #1 · answered by mopardragracer 2 · 0⤊ 0⤋
Its authentic,If the a/c compressor locks up,it would want to reason your motor vehicle to stall.or over warmth. that is ran with a unmarried force belt.the known cost for a coloration tree pastime to regulate a/c compressor and gas pump is about $one hundred fifty.
2016-12-03 05:19:11 · answer #2 · answered by ? 4 · 0⤊ 0⤋
it should work. look to see if the car was offered without a/c. if it was, get that belt and find a routing diagram. should be no problem.
2007-01-29 11:57:41 · answer #3 · answered by Anonymous · 0⤊ 0⤋
It will work- i had a 1989 oldsmobile with 3800 engine i did the same thing, never had a problem
2007-01-29 11:11:55 · answer #4 · answered by red77chevy350 4 · 0⤊ 0⤋
try to tighten the bolt on the front of the pulley
2007-01-29 11:12:42 · answer #5 · answered by Andrew N 1 · 0⤊ 0⤋