What is normal compression ratio for FORD FIESTA 1.1 ?

Question

I want to buy used Ford Fiesta 1.1.
It is about 10 years old and I don't know what compression ratio is not bad ?

Answer 1

It depends on the size of the gerbels running around in the motor cage! very underpowered regardless.

Answer 2

Gauges vary a lot. The important thing is that all the cylinders are close. You need to test with a good battery charger attached and all the plugs out. The highest cylinder shouldn't be more that 10% higher pressure than the lowest.
145psi is very high and 5psi difference is too low a threshhold.

Answer 3

Going by the manual it states 13-16 Bar or 130-160 kpa get them checked if they are within these specs and no more than 5 to 10 kpa between them the engine should be ok . note that if they are towards the 160 reading the better . good luck.

Answer 4

.when You see a person checking the time in the watch,after finish ask them what time is it? and they will look at the watch one more time .(because, the first time they ask the watch the remaining time to do a thing, and the second time is what time is it?)

there is : when You see a mechanic checking compression,He is only checking the difference of compression betwin cylinders
Not. how high is the compression rate.
the difference shouldn't be higher than 5 P S I .( or the engine is unbalanced)

Answer 5

All Fiesta keys have a micro processor geared up into them. My spouse had the comparable prob with hers and it grew to become into greater low-value for us to purchase a lock set and start up lower back. you're able to nonetheless could pay ford to establish the micro processor in spite of the undeniable fact that. i grew to become into fortunate in that my sons mate labored for them and did it for us. wish this helps.

Answer 6

Most engines don't run really well with comression below 145 psi.