how can i make a wrestling ring the cheapest way?

Question

the most cheapest

Answer 1

Its very easy, but time consuming. We actually just made one and running our first show in it 1.28.07. you will need to spend some money, we spent about 1/3 of what it would cost to buy one and have it shipped. Here's the basic idea, get 4 10 ft posts. (we used 4 inch conduit) and put them about 1 ft in the ground you can just bury it or cement it however big you want it. Ring sizes are named by the perimeter of the ropes (If a 16x16 rope size, put the posts 16.5 - 17 ft apart.) then drill holes in the posts for the ring frame, top of the frame is about 3 ft from ground level. and use bolts to fasten 2x6 wood onto them, then do the bottom of frame at ground level. bolt those on, its best to take 2x4s and create a frame support, which is pieces of 2x4 screwed into the top and bottom of frame standing vertical. then you have your frame. Then we filled the inside of the frame with old used tires from gas stations and such until it basically was to the top of the frame. take 4x8 pieces of thick plywood and lay them on top of tires to create your surface (due to tires you may need to use pieces of 2x4 to fill in gaps so plywood lays flat.). there is Ur ring frame. The ropes are 1.5 ft apart from eachother. if u need more detail and sizes email us @ [e-mail] and check out newomegawrestling.com

Answer 2

If you're a proffessional, then it'll be easier. If you're just a kid, it'll be tougher.

You need a straight surface like a wooden board or canvas or a trampoline. A kid can use a straight bed without the matresses.

Then you'll need a straight pole- steel if you will. A kid can use wood.

A few steel balls (or turnbuckles as they call it) have to be placed at three points on the steel pole. Note: The steel balls should be atleast 2 feet away from the pole. It should be kept in balance with the help of sticks or whatever. A kid can use cricket or rubber balls.

And you'll need lotsa ropes. If you can't make a hole in the steel balls, just make a loop around the ball with the rope. You'll need three long pieces of rope or 12 short pieces. Depending on the length of your ring, decide accordingly.

And voila, you have a wrestling ring.

Wait a minute, how can you make a wrestling ring without wrestlers. So, invite your friends, put on masks and rumble inside the ring. You can use those who aren't wrestling in the current match as referees and commentators.

Answer 3

two ways. the first is more professional, but just find insturctions and build a ring, its nothing but plywood, ropes, and canvas.
2nd, i saw this somewhere, it's the ghetto way. Secure plywood to old tires. the tires absorb the impact and you cover the tires and boards with some kind of fabric.
And then again, you can always use a trampoline and put up posts and ropes. But there is too much bounce and the moves dont look impressive.

Answer 4

I did this Before i just had a trampoline with a net. then i bought 24 noodles and rope. After that you put the noodles threw the holes in the noodles and tie them to a post or u can get something. and i would say about 3 noodles per rope.

Answer 5

Well,

build one yourself. These are some of the requirements:

Wood to place a matress or whatever you want to jump on:)...

Nails to fix the wood together, and make 4 poles out of wood, or iron. Poles you can get from some waste skip.

Then simple make sure nails are stuck well enough that nothing collapses... You can even get a very thick matress and simple place 4 poles one on every corner, then use ropes from one rope to another.

Karl
http://www.machgoo.ws

Answer 6

First way trampoline with some plywood then add a carpet on top some strechy ropes a few turnbuckels and voila done.
Easier way (if u hav a few quid/dollars)ebay sell loads

Answer 7

Mattress

Answer 8

buy a trampoline and improvise with metal posts and some ropes

Answer 9

buy a trampoline, or use a couple mattresses stuck together

Answer 10

???