How to wire up a ballast / starter to a mono-pin fluro tube?

Question

I have bought some rather fancy stainless steel lights for under the cabinets in my kitchen. The light is in a sealed unit and has two wires coming out of it. I have the 4W ballast and starter but I am not sure how to wire it up with only 2 inputs to the light fitting. Can anyone help?

I have the ballast wired up as required. However the issues lies with where the starter goes. In a normal fluro setup the starter would go from one end of the tube to the other. This isn't possible with my light as I only have 1 connection on each end of the light, which is currently being used for the input from the ballast and the output to the neutral.

Answer 1

How to wire the ballast in is given on the wiring diagram on the ballast. It should even give you which colored wire goes to where.

Answer 2

Check the metal box for info.