drywall help?!?

Question

could someone tell me or direct me to a good webpage for regarding fixing drywall? i need to repair a 4x4 foot "hole" in some drywall and i have never drywalled before. also, what supplies will i need? thanks!

Answer 1

This is a fabulous website with visual instructions:

http://www.easy2diy.com/cm/easy/diy_ht_3d_index.asp?page_id=35750435

Answer 2

I just want to add to the two previous answers, which are both correct.
If you have cut out the section to be repaired along the inside edge of the existing studs, the easiest way to support the patch is to cut some straight 2x4s slightly taller than the opening and nail or screw them to the existing ones. Make sure they are flush with the back surface of the drywall. Then use the 1x material (it doesn't have to be 1x2), at the top and bottom seams as per the previous answer. You will need to hold them tight to the back of the drywall while fastening the first few screws so be careful where you place your fingers (it is quite painful if you drive a screw in to your fingertip).
You can also purchase metal clips that are designed for this purpose if you prefer.
For the taping part, if you don't think you will need to do any additional repairs, you can probably find a cheap plastic set of "mud knives", as well as a "mud tray" at your local home center. Start with the narrow one and go wider with each successive layer. Also, you will achieve better results if you mix the mud in your tray until it is smooth and bubble free.

Good luck!

Answer 3

tyou don't really need a web page. Cut the area to be repaired evenly, (square, rectangle). You need a frame to give the repair strength. cut 1" x 2" board to proper length (4 pieces). fasten to the good drywall with screws overlapping the hole 1". Place the new piece into the hole, and attache it with screws. Use drywall tape with adhesive, place over the splices, all around. Spread a thin layer of mud over the tape, let is dry. Place another thin layer over it and a little wider, let it dry and a third thin layer, wider still. Let it dry sand lightly prime and paint. You may have to paint the whole wall to make the paint blend.

Answer 4

Determine the thickness of your existing drywall (3/8, 1/2, 5/8").
Cut out existing drywall from center of stud to center of stud.
Cut new drywall with razor knife and fit into hole.
Use drywall nails or screws and fasten to studs.
Use drywall tape (self adhesive) cut and place over joints.
Get a gallon of drywall mud and trial a thin layer over screws and tape.
Let dry overnight.
Lightly sand out ridges and excess.
Apply another thin coat of drywall mud to even out and let dry overnight.
May need to lightly sand again to make a smooth finish.
Now youre ready to prime and paint.