English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

When i connect my usb drive to pc it gives error that usb cant be recognised and has malfunctioned?
the usb's version is 2 n my pc also supports ver2
that usb used to work properly

plz tell me why this msg appers n what should i do to make my usb working

2007-01-22 23:10:39 · 4 answers · asked by Wolverine 2 in Computers & Internet Hardware Other - Hardware

4 answers

If it is the USB for ur internet connection or any type of connection then you should go to control panel then into phones and modems and then into the tab named as "modems" and then see whether the kind of internet you are using is mentioned there or not eg. if u r using LG TATA phone then you shouls see whether LG is written there or not. If its not then you should put the cd of your phone and install the modems again.

If it is the USB of something else then there is something wrong with you USB. CHANGE THE USB

2007-01-23 00:05:52 · answer #1 · answered by Anonymous · 0 0

depends on what the device is and whether you have the right drivers installed. If its a camera it may not be on or set to usb connection. If its a flash drive it could be right protected and your pc can't read the contents. Check the drivers and what the device manager says the device is, could be getting misidentified.

2007-01-22 23:17:50 · answer #2 · answered by Helping Since 1969 6 · 0 0

Sounds like yourr usb is corrupted. This could have been caused by disconnecting from pc incorrectly. Try the usb in another computer and see if it functions there. If it does, try reloading usb drivers on your pc.

2007-01-22 23:17:00 · answer #3 · answered by tw0cl0n3m3 6 · 0 0

Go to the hardward device manager and see if you have listing for a 2.0 USB Enhanced host controller without an exclamation mark

Make sure your drivers are up to date

2007-01-22 23:19:39 · answer #4 · answered by Anonymous · 1 0

fedest.com, questions and answers