2000 hyundai elantra help?

Question

i have a 2000 hyundai elantra that needs front wheel bearings. i was wondering if they needed to be pressed or not

Answer 1

Front bearings these days come complete with the knuckle, costs a lot more.

Answer 2

The examine engine mild is promptly bearing directly to the emissions. hence no remember if that's on, its using fact between the sensors shows theres something incorrect. a undemanding (and elementary to restoration) difficulty is that if the gasoline cap isn't completely closed. the vehicle can tell if gasoline vapor is leaking accessible. although the greater undemanding difficulty with it relatively is typically with the oxygen sensor. yet i gets to that for the period of a 2nd. to respond to your question: Autozone provides the provider to plug your vehicle into their workstation for loose to diagnose what the difficulty is. Its a large way for them to sell you the areas to maintain your vehicle. they could additionally sparkling the workstation. (or you could disconnect your battery in one day). After the workstation has been reset - you will could force for a complete primary day - it relatively is approximately quarter-hour at 30 mph, quarter-hour at 50 mph or greater, and a few provide up and pass in there as nicely. this might enable the workstation to run by using all its exams. If it comes back on then there's a difficulty. the main undemanding difficulty while the sunshine comes on is the oxygen sensor. Its embedded interior the exhaust device - as such difficulty to very extreme warmth. maximum greater contemporary automobiles are equipped with a minimum of two. One in the previous the catalytic convertor and one after. They deliver messages to the workstation which compares them to work out if the catalyic convertor is working correct. It in basic terms approximately consistently is. The oxygen sensor is probable whats broken. they are an elementary restoration in case you have have been given the kit, although to understand which one to replace is a challange. something like which will nicely be repaired at any shop or the broker. shouldn't value too lots.

Answer 3

yes they are pressed. yes the need to be pressed.

do You have the bearing ? machine shop.
you can not find the bearings? machine shop.

Answer 4

you have two choices. if you buy it from the dealers,it come with a hub(bearing and hub assembly). if you buy it aftermarket or from a parts store, you will have to pay extra to have the bearing press in.