Mazda B3000 truck interior light?

Question

Is there a bad wire problem ? Bulb is burned and smoke came out from there after engine off and door opened for a while, fuse have not burn, this happened after replaced fuse(same rate) and new bulb after week.

Answer 1

It may be a short.
Check to see if the harness to the interior light is bad as well.
If the fuse isnt blown then the problem lies between the interior light harness and the junction box.

Answer 2

That lots funds won't produce relatively some overall performance. I placed ok&N air filters in all my automobiles (or a similiar product) and sense that the money replaced into nicely spent. you could likely fab your individual chilly air intake. This too might help, how lots i'm unsure. As for exhaust, I initiate with tuned headers. i like 2-2-a million (tri-wye to previous schoolers). they seem to artwork superb interior the RPM levels maximum individuals force in (mid-variety). the the remainder of the exhaust must be finished with warning. pass to important (or no longer adequate back tension) and you will loose the backside end. I pay attention X pipes artwork as nicely or greater advantageous the H pipes while you're going actual duals. however the factor that expenditures the least is to purely shop the factor tuned up, the injectors sparkling. additionally the wieght distribution on a truck is way less then acceptable, it would help to place some kilos of ballast on the rear wheels. mutually because it ought to in no way be a screamer, it relatively is greater relaxing to force with some descreat impovements. by using the way, have you ever seen searching for a used SHO engine to bolt in there? no remember if that's a Ford 3.0 based engine one in basic terms might greater healthful. Or another 24 valve engine could greater healthful.

Answer 3

make sure your have clean hands and fingers and clean out the fuse holder

Answer 4

I would check the contacts and make sure they are clean