where in my engine do i spray damp start?

Answer 1

Basically as much of your ignition system as you can get at, i.e. plugs, points (if you have). HT cable ends, coil, distributor.

Answer 2

hi . read these answers carefully . there seems to be some confusion whether you are using 'damp start ' or 'easy start ' . damp start is a water repellant and therefore you spray it on electrical components as explained by other answers . if it is easy start , this is a engine starter fuel and you need to use this to help start an engine . this can be sprayed into the air intake , but take care here and do as instructed on the can , it is highly flamable and can explode with a backfire .

Answer 3

Dodge man you got it......into the breather it is alchohol and ether to give the engine that hot kick....when??? when it is damp!! The other answers are confusing the question if your engine misfires or the ignition shorts spraying the cables and distributor with WD 40 or something usually fixes that.....

Answer 4

Direct it towards the spark plugs and distributor and on the plug cables. If in doubt spray the whole engine.

Answer 5

you spray it in to the breather ,,usually with the breather off if it,,but it can be put in to the end of the air tube,,the problem is this stuff evaporates really fast,,so it usually takes two people to do this,,but you can do it by your self just hurry and get it cranked over ,,good luck,i hope this hep,s

Answer 6

All over, and then let it dry!!! IT will remove the water and dampness..

Answer 7

If it is carburator then in the top of the carb. If it is fuel injected...dont try it

Answer 8

HT leads,wiring ,distributer.

Answer 9

on your key when its damp

Answer 10

The window?