For computer Geeks: Can i use a 400Mhz ram on this motherboard...?

Question

the mother is SoyoP4VGM
heres the site, but i dont quite get it: http://www.soyo.com/products/proddesc.php?t=d&id=273

Answer 1

I'll say it again, you can use the 400Mhz RAM on it, but it will not run at 400Mhz, it will run at 266Mhz. If you already own the board and are looking to buy 400, then go ahead, but it will not run at that speed. If you are shopping for a board to run 400Mhz RAM at 400Mhz speed, this is not the board because it will only run it at 266Mhz.

Answer 2

Generally speaking, as long as the RAM phisically fits into the motherboard, it'll work with it. On the other hand, it's not optimal to do. Your motherboard are designed to accept RAMs that runs on 200 or 266 MHz.
Even if you put this particular RAM in the motherboard and it works (most likely it will), it'll only perform at 266 MHz, the highest the MB can support. However, it can accept 2 GB or RAM, so instead of investing into speed, try to put your money towards the amount of memory you will use.
I hope this helps a bit...

Answer 3

The link you provide says that the mobo supports:
System Memory Description * Two 184-pin DDR SDRAM 2.5V DIMM sockets support up to 2GB (DDR 200/266)

Therefore if the memory you propose to install into this machine is the same type, there is no problem. You propose to install faster memory than is required which will work ( but only at the mobo bus speed). If you installed memory of lower speed, it wouldn't work.

Answer 4

What you are able to desire to do is reset your BIOS so as that it incredibly is going to be compelled to re-stumble on your previous reminiscence. It sounds to me that as quickly as you place the different RAM in, the settings went out of selection, and are nonetheless being held in the CMOS settings. until eventually now you place the previous RAM lower back in, look at your motherboard and discover the button-cellular battery. close to that could desire to be a three-pin jumper. good now that jumper is on the two Pin a million and a pair of, or 2 and 3. Whichever set of pins the jumper is at the instant on is the reminiscence carry. If the jumper is at the instant on Pin a million and a pair of, then pass it to 2 and 3, and wait 10 seconds. comparable in opposite....if the jumper is on Pin 2 and 3, then pass it to a million and a pair of and wait 10 seconds. as quickly as the ten seconds passes, pass the jumper lower back to its unique place, then installation your previous reminiscence, and stir up the device. From right here you will could desire to bypass into your BIOS settings and re-setup each and every little thing wisely. as quickly as carried out, shop the settings, and the device will boot in many circumstances. Written via WEOIII NCT, NST qualified community/laptop Technician

Answer 5

Yes you can it will work but it will run at 266Mhz.

That's 133Mhz in true speed which you multiply by 2 = 266DDR.

But if you can manage to overclock your CPU, then you will be able to get more out of your memory.

Depending on how good your chip overclocks you may be able to run the memory at 300DDR or even get closer to 350DDR.

Good Luck.