Does any one know how to fit a trickle vent into a double glazed window, also where could i purchas one thanks

Answer 1

yes you can. i assume you want to cut it into the frame at the top horizontal rail. you can buy either a 2000cm2 or a 4000cm2 plastic over mounted one from a double glazing manufacturer or local friendly d/g glass shop. then you can drill a series of holes right through the frame and mount the pieces either side over the holes . you must drill a whole series of holes ( as many as poss. to get the most ventilation , you don't have to "wobble" the drill to make a slot . for your information i live in u.k. i suddenly thought you might be in a different country , then maybe you can't get this item . so sorry if that is the case.

Answer 2

I often have to do this, but you need to check there's enough frame for the vent, because normally if your having a vent they make the window shorter in height and then the vent goes on a add on that's fitted on top of the window. Also when drilling the holes for the vent , make sure to drill on the side where the glazing beads are so that in drilling over the top of the glazing bead you will avoid hitting the s/u. If it's just for ventilation and not because there's a boiler in that particular room then it's up to you how many holes you drill else you should contact the gas board as there are strict regs on the size of the vent required. you should be able to purchase at most diy stores without a problem

Answer 3

is the window a PVC one ?.
if so you will already have a trickle vent system installed.
all you need to do is all most close the window and pull the handle down this can be locked in this position. the window is not fully closed therefore allowing some air through.
hope this helps and saves you money.
please let us know if this works.

Answer 4

Do not even try often double glazed windows have either an inert gas between pains or slight vacuum? This is for insulation and places glass under a significant strain. Glass may shatter when you try to cut it. This could cause significant personal injury or even death.

I repeat do not do this unless you are a professional glazier & then you would not need to ask this question!

Answer 5

would not be a good idea....these are cut in during the manufacturing process. better to get a core vent through wall and get a closeable vent for it. another point, trickle vents are no use for a gas appliance ventilation.

Answer 6

You will have to remove the sealed unit from the window, and then go to a glazier who will separate the two panes, cut a matching hole in each piece and then reassemble with a spacer in the new hole to enable the vent to be tightened up in the hole. You will then be able to refit the unit back into the frame.

Answer 7

Get a pro.This requires the use of tools,