how to configure cisco router's ip accounting to record input and output packets of hosts based on ips?

Question

cisco routers have a service called ip accounting.
i telnet to the router , select the FastEthernet0/0 interface
and then write "ip accounting"
then i save the router's configuration
when i use "show ip accounting" i only get local ip addresses as destination , not as source , which means that i see only who in my network makes download , not who makes upload.
can any one help?
NOTE : i dont need to have accounting by MAC Addresses , but i need the accounting table by IP addresses.

Thanks

Answer 1

Perhaps your filter list is not set up properly. Have you cleared it and reset the database? Do this with the "clear ip accounting" and then do a "show ip accounting" again. Also try using the "show ip accounting checkpoint" command. Have you gone through the Cisco documentation for the version of IOS you're using? Example link below. This also has some configuration examples.

Answer 2

Show Ip Accounting

Answer 3

This Site Might Help You.

RE:
how to configure cisco router's ip accounting to record input and output packets of hosts based on ips?
cisco routers have a service called ip accounting.
i telnet to the router , select the FastEthernet0/0 interface
and then write "ip accounting"
then i save the router's configuration
when i use "show ip accounting" i only get local ip addresses as destination , not as...