Where does a inline fuel filter go on a '94 chevy truck 350 V8 2500.?

Answer 1

Almost directly underneath the driver's seat on the inside of the frame rail. You will need a 13/16th and a 5/8th wrench to remove the nuts from the filter. (Some aftermarket filter use a 3/4). Once nuts are loosened, fully disengage nuts from filter. There is usually some residual pressure here, so bump or move the filter or one of the lines to let it drain off. Pry the gas pipe from the locator plastic holder on the upflow side and hang the pipe away for access to remove the filter from its plastic holder. These can sometimes be a bit sticky so wiggle and tap. Once removed, ensure both of the o-rings on the pipe ends are okay and if not, replace. A little lube on the filters outside will make shoving it into the holder a lot easier. Install filter and pipes. Spray some lube where the upper pipe was removed and re-attach the pipe into the plastic holder. Tighten both nuts and check for leaks. Good luck.

Answer 2

along the leftside of the frame rail, about 1/2 way between the tank and the engine. it's on the inside (between) the rails.

Answer 3

drivers side frame rail near the fuel tank. if u cant find it follow the fuel lines from the tank to the front of your truck.

Answer 4

Leftside frame rail between engine and tank. It's closer to the tank.

Answer 5

I generally agree w/Dodgeman, but this time it's on the inner frame driver's side, where the bed and cab meet(appx)I've got a 97 k1500.

Answer 6

i mechanic for a living,,and its mounted on the inside of the frame rail on the passengers side about half way between the tank and the engine,,good luck hope this help,s.

Answer 7

Its on the frame half way back

Answer 8

Yuppers, Leftie side frame rail.

Should look something like this :)

http://www.gmpartszone.com/PartPictures/33254%20pi_filt_fuel.jpg


*Note, yours may not look as shinney